Category: Knowledge Base RSA3000 Series

Built-in scan table with independent settings for each range make it easy to configure complex scans with multiple detectors all on one screen.

Analyse data from a completed scan against limit lines and search for peaks. Isolate these signals for further examination automatically.

Once the testing and debugging is complete, use the EMI Measurement Application to generate complete test reports with notes, screenshots, and data. Integrate test, debug, and reporting all on one platform for consistency and productivity. Watch the EMI Mode create html and pdf reports for the test archive.

An important first step for Pre-Compliance is selecting the detectors to start with. Different detectors may limit your sweep speed and change the meaning of the results. Learn how to set up detectors and traces.

Pre-Compliance testing is about more than just recording emissions. Use the EMI Application to compare between board revisions making sure the product is getting close to compliance as it gets closer to launch.

EMI Mode shows live measurements of markers or signals against multiple detectors simultaneously simplifying comparison and analysis.

For DSA875/832/832E:

If you experience a defective UltraSpectrum display while connected to a DSA875/DSA832/DSA832E series spectrum analyser, the most likely cause is due to a UltraSpectrum and firmware version mismatch. To correct the issue, download the firmware version 1.06 for DSA875/DSA832/DSA832E from the below download tab at:

https://beyondmeasure.rigoltech.com/acton/attachment/1579/f-013e5a2f-c1c7-4f1f-9010-1dd1818f10df/1/-/-/-/-/DSA875_832_FW_v1_06.zip

Here is an example of the UltraSpectrum display using an incompatible version of firmware:

For RSA5000/3000 series

The new firmware on RSA3000 & RSA5000 has Web Control function. Instead of using UltraSpectrum, the Web Control is free with the latest Firmware and much better than UltraSpectrum as it works in multiple modes.

To set up the Web Control, connect the Spectrum Analyser to a PC with a LAN cable.

Turn on the Web Control by : System->Display->next page Web Control->On

Press System->Interface->LAN to get the IP address.

Type the IP address in web browser on the PC and you will be presented with the Web Control Welcome  screen.

Click Web control, the display of the RSA will appear on the PC screen along with the selectable menu.